Sorry for English. From README
---------------------snip----------------
If you insert a card into a interface the card is autodetected (your interface
should use the CD line to signal card presence or it won't work) and
initialised (this may take some seconds to complete). You can use the setup
menu to see which cards are currently inserted and detected. You can remove a
smartcard at any time without prior action, but of course this will disrupt
decryption if you are tuned to a channel which requires the card.
The activation of the SC is controlled by your CICAM setup. As general setup
(which is not SC specific) all encrypted channels must have a CA value filled
in (in channels.conf) and the DVB cards which should receive the channels must
have proper CICAM values set.
In the plugin setup menu, you now have to specify for which CICAM values the SC
should kick in. The first two CICAM caps can be setup from the menu. If you
need more, you can edit the setup.conf file manualy and add up to 10 CICAM
caps.
Doing so, SC is activated on all cards which have atleast set one of the plugin
CICAM caps BUT only for channels which have a CA value which is listed in the
plugin CICAM caps.
Example:
ORF 2:12692:h:S19.2E:22000:500:501:505:102:13002:0:0:0
PR Start:11798:h:S19.2E:27500:255:256:0:101:8:0:0:0
To receive both channels with one DVB card, you would have to set the DVB CICAM
to 101 102. If you set the SC CICAM caps to 101 102 too, SC will kick in for
both channels. If you set the SC CICAM caps to 102 only, the second channels is
left alone (may be to be decrypted by a hardware cam).
----------------------snap---------------------------